When to use backer rod

Shop the products for this jobShop all products →
Backer rodBuy Backer rod ↗PRESCHBuy PRESCH ↗

A PE backing rod controls bead depth and separates the sealant from the base. Measure the joint before choosing its diameter.

Rogier · Silicrack

Why there is backer rod behind a sealant joint
Short answer

Backer rod is not cheap filler. It stops three-sided adhesion and sets how deep the silicone sits. Without it, a deep joint often tears or peels when the building moves.

See tools and materials ↓

Buying through a product link may earn us a commission at no extra cost to you.

What the PE rod does inside the joint

An elastic joint should bond to two flanks and be free to change shape. If it also sticks to the back of the gap (tile adhesive, cement, a board), you have three-sided adhesion. Movement then pulls a rigid plug. The bead tears in the middle (cohesion) or lets go of a flank (adhesion). In a shower that path lets water behind the tiling.

Closed-cell PE Backer rod does three jobs:

  1. It sets sealant depth instead of letting you flood the void.
  2. It is a non-stick back, so the bead works on two faces.
  3. It gives something to press against, so the silicone wets the flanks.

It is not a trick to save money on silicone. Open-cell foam in a wet room acts like a sponge and can hold moisture behind the joint. Newspaper, wool or cardboard rot. Use closed-cell PE.

Before opening the cartridge, try the Presch silicone gun in the tightest corner. Check you can turn your wrist and release pressure at the end of the run.

When to use it — and when not

Use it when the gap is deeper than the sealant thickness you want, and when the back is cement or adhesive.

Do not ram rod into a joint so shallow that the foam will not sit (often under about 5 mm deep). Then a PE bond-breaker tape on the back is the usual way to free the third face.

Do not use elastic rod in a rigid, fully filled mortar or filler joint. That is a different detail.

A common size rule on site is a rod about 20–30 % wider than the gap so it wedges and stays while you gun. Push it in with blunt tools. If you pierce the skin, gas can bubble through the fresh silicone.

Dry-fit the FUGENFUX profiling tool. Choose the edge that meets both sides without scooping out the middle, then tool the bead before a skin forms.

Depth in outline

For many elastic joints, a width-to-depth ratio around 1:1 on narrower gaps (often under about 10 mm) and closer to 2:1 on wider ones is the usual workshop starting point. It is a geometry habit, not a substitute for the silicone’s own joint-design notes. The rod is the stop that lets you hit that section.

After the rod is in

Clean the flanks, degrease, primer if the substrate needs it, gun the joint full without voids, and tool it. If you are replacing a failed shower joint, check whether the old rod is wet or torn and replace it.

Tools and materials for this job

  • Backer rod

    For depth control where specified. Choose the diameter to suit the measured width.

  • Presch silicone gun

    Manual cartridge gun. Check you can release pressure in the last centimetre.

  • FUGENFUX

    Profiling tool. Dry-fit the edge that reaches both sides of the joint.

Exceptions

A moving shower tray still has to be supported first. Correct backer rod will not hold a rocking tray. Three-sided adhesion is the joint-shape problem; support is the construction problem.

More on this

Guides · Prep & joint design

How deep should a sealant joint be? →