Why sealant needs two-sided adhesion
Look at a cross-section. The sides hold the bead. A third bond at the base restricts the material that can stretch.
An elastic joint should grab two faces, not three. PE backer rod releases the back. Packing the void with paste does not make it stronger: it makes it stiffer.
Buying through a product link may earn us a commission at no extra cost to you.
What happens when the bead bonds to the base
Three-sided adhesion is when the bead bonds not only to the two flanks of the joint but also to the plane behind: tile adhesive, concrete, the back of a profile. Elastic sealant needs to change shape between two faces. If the back holds it as well, movement piles up at the edges. Then it either tears through the middle (cohesion) or lets go of a flank (adhesion).
Think of a rubber band. Pulled from both ends, stretch spreads. Stick the back to a wall and pull: that point cannot extend. All the load goes to the ends. In a bathroom joint, the typical movement class of an elastic silicone — on the order of 20–25 %, not a guarantee for that joint — collapses. You are left with a few per cent.
A void packed with silicone is not “stronger”. It has more contact faces and fails sooner.
Before opening the cartridge, try the Presch silicone gun in the tightest corner. Check you can turn your wrist and release pressure at the end of the run.
When to use it — and when not
Yes, backer rod of closed-cell PE when there is depth to spare. PE does not bond; it frees the back and sets the geometry.
If the joint is too shallow for a rod, PE tape or foil on the back is the bond-breaker.
More paste will not save it if the movement is slab settlement or a badly framed partition. Stabilise the build first. Backer rod will not hold a structural crack.
In the wet, closed-cell PE only. Open-cell foam is a sponge: water behind the bead and mould.
Dry-fit the FUGENFUX profiling tool. Choose the edge that meets both sides without scooping out the middle, then tool the bead before a skin forms.
How I do it
- Cut out the old joint and the hard adhesive that has squeezed into the corner. When you scrape, do not nick the waterproofing under the tiles.
- Check width and depth; the section has to make sense.
- Push in rod 20–30 % fatter than the gap, wedged, not crushed flat.
- Degrease the flanks, one direction, a lint-free cloth.
- Sanitary silicone or an elastic sealant that wets both faces. Tool it.
On tiling, if adhesive fills the internal corner and cures, that is the third plane. The tiler should leave room for the PE. If not, you scrape it before you seal.
Tools and materials for this job

Backer rod
For depth control where specified. Choose the diameter to suit the measured width.

Presch silicone gun
Manual cartridge gun. Check you can release pressure in the last centimetre.

FUGENFUX
Profiling tool. Dry-fit the edge that reaches both sides of the joint.
Exceptions
A rigid mortar joint does not take elastic Backer rod. A rocking shower tray is a support problem, not a bead-shape problem.