How to seal windows inside and out
Distinguish the frame-to-wall joint from a glazing seal. Inside you may want paint. Outside check rain, sun and movement.
Inside: paintable, continuous, tighter to air. Outside: UV and rain, not living-room acrylic. Glazing silicone is not the wall-to-frame joint.
Buying through a product link may earn us a commission at no extra cost to you.
What the interior frame joint needs
A fixed joint between the frame and the painted reveal needs to keep air out and accept the intended finish. On a dry, compatible connection with limited movement, try OTTOSEAL A205 with your paint on a sample. The gasket on the opening sash is a separate part; keep sealant off it.
Outside, check both bonding faces
At the junction of the frame and masonry, check the expected movement, exposure to rain and the sealant data sheet for both surfaces. OTTOSEAL S110 is a neutral construction silicone for suitable window and façade joints. Pick the finished colour now; do not plan to paint over it. Glazing and frame-to-wall sealing are different details.
When to stop
Do not cover a rotten sill, a frame that has dropped or water coming from the wall cavity. Keep drainage slots clear. Ask the installer to identify the intended air and weather seals before filling an unfamiliar opening.
Dry-run the corner before applying
- Measure width and depth at both ends, not just in the middle. Follow the frame system’s joint detail. Where a deep designed joint needs depth control, fit the specified backing without bonding the bead on three sides.
- Clean and dry both edges using the preparation specified for the actual materials. If a primer is required, respect its flash-off time.
- Offer up the Presch silicone gun before opening the cartridge. Turn the bottom corner and check that you can release the pressure without stopping over the same spot.
- Choose the edge of the FUGENFUX that bridges both sides of the seam. Make one steady pass before a skin forms. On exterior silicone, use Smoothing spray sparingly only if the silicone sheet permits it; keep it off the bonding faces.
Tools and materials for this job

OTTOSEAL A205
For a dry joint that will be painted. Check movement and paint compatibility.

OTTOSEAL S110
Neutral construction silicone. Check both substrates on the data sheet.

Presch silicone gun
Manual cartridge gun. Check you can release pressure in the last centimetre.

FUGENFUX
Profiling tool. Dry-fit the edge that reaches both sides of the joint.

Smoothing spray
For tooling silicone where the manufacturer allows this agent. Keep bonding faces dry.
Before painting or exposing the joint to rain
Check the curing and weather-exposure instructions for the cartridge you used. A sanitary label by itself does not establish façade suitability. On the inside, make a small paint test; a paintable sealant can still move more than its paint film.