How long does bathroom sealant last?
Check adhesion on both sides and look for standing water. Age alone tells you little about whether the bead needs replacing.
A well-made, well-kept shower joint often lasts about 5–8 years; kitchens a little longer; outside glazing often longer still if product and movement match. There is no universal “fifteen years”.
Buying through a product link may earn us a commission at no extra cost to you.
How to recognise an ageing bead
Silicone does not “expire” on a Tuesday. It loses plasticisers and polymer to heat, soap, chlorine and UV. It goes hard, stops following the substrate and opens or peels. A decent cartridge lasts longer; a filler-heavy one, less. Use beats the label.
The spans below are orders of magnitude, not a guarantee and not a company slogan.
If one edge is marble or natural stone, trial OTTOSEAL S70 on an offcut and check the tooling agent before touching the visible surface.
By room, from the job
Shower and wet zone. Often 5–8 years. Soap, skin grease, heat, limescale cleaner. Signs: peel at the tray, mould in the mass, rubber that no longer springs back.
Kitchen worktop. Often 8–12 years if it is not behind a hob that fries. The enemy is grease and heat. It yellows or opens on the back edge.
Windows and glass outside. With a proper glazing sealant and a joint that can move, sometimes 15–25 years. UV and thermal cycling mark it. Crazing or a dusty face: it is finishing.
Movement joints in floors or façades. Often 10–15 years, depending on movement and chemistry. A split down the middle: cohesion; the rubber has nothing left.
Where the detail calls for sanitary silicone on two compatible surfaces, consider OTTOSEAL S100. Porous stone needs a stone-compatible product.
When to replace and when to wait
Replace if it has peeled, if there are black specks in the mass, if it is hard like plastic, or if there are hairlines in the corner of the bead. Wait if it is only dirty or a bit yellow and, pressed with a nail, it springs back.
Raking light shows open edges. The nail tells you if it is still alive.
Before opening the cartridge, try the Presch silicone gun in the tightest corner. Check you can turn your wrist and release pressure at the end of the run.
What shortens it
Chlorine: kills fungicides and the rubber. Acrylic in the shower: not for standing water. Over old silicone: months, not years. No primer on a substrate that needs it: it opens in a couple of years. Three-sided adhesion without backer rod: life is halved.
A professional silicone (I use OTTOSEAL in the wet zone) carries fewer fillers; it stays elastic longer. It is not magic: leave it in a puddle and it still fails.
Clear shows more of what sits behind it; colour itself barely changes life.
Dry-fit the FUGENFUX profiling tool. Choose the edge that meets both sides without scooping out the middle, then tool the bead before a skin forms.
Tools and materials for this job

OTTOSEAL S100
Sanitary silicone for compatible surfaces. Check both edges before opening the cartridge.

OTTOSEAL S70
For compatible natural stone. Test colour and finish on an offcut.

Presch silicone gun
Manual cartridge gun. Check you can release pressure in the last centimetre.

FUGENFUX
Profiling tool. Dry-fit the edge that reaches both sides of the joint.
Exceptions
A neighbour on 10 years and you on 3: almost always cleaning chemistry, ventilation or a badly designed meeting, not “bad luck”. Inspect; do not wait for the stain on the ceiling below.