Replace the shower bead or investigate the bathroom?

Shop the products for this jobShop all products →
S100Buy S100 ↗Smoothing sprayBuy Smoothing spray ↗

A worn bead and a leak behind the tiles can look alike. Check stability, the water path and any damage before cutting.

Rogier · Silicrack

See tools and materials ↓

Buying through a product link may earn us a commission at no extra cost to you.

Check for movement and concealed leaks

Dry each run and shine a light along the edge. If other junctions remain bonded, limit the work to the affected joint. Replace the continuous run rather than laying a patch over old silicone.

Where the detail calls for sanitary silicone on two compatible surfaces, consider OTTOSEAL S100. Porous stone needs a stone-compatible product.

If the sealant allows a Smoothing spray, use it sparingly when tooling silicone. Keep it off the bonding faces and check for staining before using it on stone.

If several joints fail on the same side

Check fixings, movement and compatibility before choosing a cartridge. S100 can suit compatible sanitary tile; natural stone needs a specifically suitable product. Correct a moving tray’s support before sealing.

If one edge is marble or natural stone, trial OTTOSEAL S70 on an offcut and check the tooling agent before touching the visible surface.

Dry-fit the FUGENFUX profiling tool. Choose the edge that meets both sides without scooping out the middle, then tool the bead before a skin forms.

Draw the repair limits

Mark the horizontal tray edge and the two verticals that meet it. Inspect behind the taps with a torch. Mark sound and detached sections and identify which discovery during removal would require extending the repair.

Renew an old shower joint · Spanish audio
For this jobOTTOSEAL S100 ↗ For sanitary joints on compatible surfaces Presch silicone gun ↗ For laying a bead from a cartridge FUGENFUX ↗ For shaping the fresh bead
Check surface compatibility and the selected shade at the shop.

Before opening the cartridge, try the Presch silicone gun in the tightest corner. Check you can turn your wrist and release pressure at the end of the run.

Tools and materials for this job

  • OTTOSEAL S100

    Sanitary silicone for compatible surfaces. Check both edges before opening the cartridge.

  • OTTOSEAL S70

    For compatible natural stone. Test colour and finish on an offcut.

  • Presch silicone gun

    Manual cartridge gun. Check you can release pressure in the last centimetre.

  • FUGENFUX

    Profiling tool. Dry-fit the edge that reaches both sides of the joint.

  • Smoothing spray

    For tooling silicone where the manufacturer allows this agent. Keep bonding faces dry.

Can I patch a two-centimetre gap?

Avoid sandwiching a new patch between old ends unless the system specifically allows it. Identify natural endpoints and redo the run on prepared surfaces.

The joint peeling off the tray or bath

How to remove old silicone without damaging the surface →