Odour when sealing: how to plan ventilation

Shop the products for this jobShop all products →
S110Buy S110 ↗PRESCHBuy PRESCH ↗

Read the cartridge information and arrange ventilation before starting. Smell alone does not measure emissions.

Rogier · Silicrack

See tools and materials ↓

Buying through a product link may earn us a commission at no extra cost to you.

Read the product information and arrange ventilation

Check the safety data sheet and instructions for indoor use. If low emissions matter, look for a declaration for the exact product and use. “Neutral cure” and “low odour” are not emission ratings.

Check the exact OTTOSEAL S110 cartridge for its EC1 PLUS emission classification and suitability for your joint. The classification does not replace ventilation instructions.

Plan the work and the downtime

Prepare the surfaces and size the nozzle to avoid waste. Arrange ventilation and time out of use as instructed. Postpone the job if you cannot meet those conditions. A gun helps with dosing but does not change the product’s emissions.

Before opening the cartridge, try the Presch silicone gun in the tightest corner. Check you can turn your wrist and release pressure at the end of the run.

Keep the reference number

Compare the cartridge code with the emissions declaration rather than relying on the product family name. Keep the sheet and application date. An air freshener changes what you smell, not the curing conditions.

Tools and materials for this job

  • OTTOSEAL S110

    Neutral construction silicone. Check both substrates on the data sheet.

  • Presch silicone gun

    Manual cartridge gun. Check you can release pressure in the last centimetre.

Is opening a window enough to sleep in the room again?

There is no universal waiting time. Follow the product instructions and consider actual ventilation throughout curing.

Acetoxy or neutral: the vinegar smell is not a fault

Choosing a sealant for outdoor joints →