Which edges of a vanity basin need sealant?

Shop the products for this jobShop all products →
S100Buy S100 ↗S70Buy S70 ↗

Distinguish the wall joint, the support on the unit and the tap seals. Locate the first drop before choosing an edge to treat.

Rogier · Silicrack

See tools and materials ↓

Buying through a product link may earn us a commission at no extra cost to you.

Identify the support, rim and waste

A rocking basin needs stable support. The tap and waste may have their own gaskets. A surface bead can hide a leak from underneath without repairing it.

Where the detail calls for sanitary silicone on two compatible surfaces, consider OTTOSEAL S100. Porous stone needs a stone-compatible product.

If one edge is marble or natural stone, trial OTTOSEAL S70 on an offcut and check the tooling agent before touching the visible surface.

Inspect the rear edge

Where the manufacturer requires a splash seal, identify the vanity material and check the cartridge against both surfaces. S100 can suit compatible sanitary surfaces. Use a light behind the bowl and retain access to the trap and fittings.

Run a fine bead behind a basin · Spanish audio
For this jobOTTOSEAL S100 ↗ For sanitary joints on compatible surfaces Presch silicone gun ↗ For laying a bead from a cartridge FUGENFUX ↗ For shaping the fresh bead
Check surface compatibility and the selected shade at the shop.

Try the Presch silicone gun behind the tap before final assembly. Check the clearance for your hand and the trigger as you turn the corner.

Practise behind the tap

Offer up the empty gun and check whether the tool can turn the last corner. If the tap is not fitted yet, agree the order with the installer. A swollen panel needs the water source and board condition investigated before sealing.

Try the FUGENFUX profile behind the basin. If you cannot finish the pass, agree on a sequence that leaves the tap out until you are done.

Tools and materials for this job

  • OTTOSEAL S100

    Sanitary silicone for compatible surfaces. Check both edges before opening the cartridge.

  • OTTOSEAL S70

    For compatible natural stone. Test colour and finish on an offcut.

  • Presch silicone gun

    Manual cartridge gun. Check you can release pressure in the last centimetre.

  • FUGENFUX

    Profiling tool. Dry-fit the edge that reaches both sides of the joint.

Should I seal the side of the unit to the wall?

Only if the installation detail calls for it. Keep doors, drawers and removable panels free. Photograph hidden seals before fitting the basin.

Tap and basin: why that joint splits first

Where to seal around a tap and basin →