How to practise running and tooling a sealant bead

Shop the products for this jobShop all products →
PRESCHBuy PRESCH ↗MakitaBuy Makita ↗

Start with a straight practice joint. Repeat the start, stop and turn into a corner before working on a visible surface.

Rogier · Silicrack

See tools and materials ↓

Buying through a product link may earn us a commission at no extra cost to you.

Practise starting and stopping the bead

Make a vertical run, an inside corner and a junction between two materials. Keep the data sheet and record conditions, preparation and date. Once cured, check where any separation occurs and ask someone experienced to review it.

Before opening the cartridge, try the Presch silicone gun in the tightest corner. Check you can turn your wrist and release pressure at the end of the run.

For repeated long runs, compare a Makita electric gun with the manual gun using the same nozzle opening. Check cartridge fit, feed control and stopping behaviour first.

Scope the first job

Write down what you will remove, what you will apply and when the area can be used again. Count travel, protection and clean-up time. Check local requirements for trading and insurance. A shower with concealed damage is a poor first practice job.

When preparing a fresh cartridge, use the Stanley knife as instructed. Cut the nozzle away from your fingers. This cartridge tool is not a scraper for glass, fabric or a shower tray.

Record what changes between attempts

Make two identical samples and change only travel speed. After the specified cure, compare bead thickness in the middle and at the end. Note where your wrist lacked support. Use that observation to plan access and explain the time required.

Shape the bead with Fugenfux · Spanish audio
In the videoFUGENFUX ↗ For shaping the fresh bead
For this jobSmoothing spray ↗ For tooling when approved for the sealant Presch silicone gun ↗ For laying a bead from a cartridge
Check surface compatibility and the selected shade at the shop.

Dry-fit the FUGENFUX profiling tool. Choose the edge that meets both sides without scooping out the middle, then tool the bead before a skin forms.

Tools and materials for this job

  • Presch silicone gun

    Manual cartridge gun. Check you can release pressure in the last centimetre.

  • Stanley knife

    For opening the cartridge and trimming the nozzle, not scraping delicate surfaces.

  • FUGENFUX

    Profiling tool. Dry-fit the edge that reaches both sides of the joint.

  • Makita electric gun

    Powered gun for repeated runs. Check pack size, speed settings and battery.

How do I know if my sample worked?

Keep a reference and inspect the edges after the stated cure. Ask for a specific preparation, shape or dosing fault before repeating the exercise.

How do you stop a sealant gun leaving a blob at the end?

How to stop a sealant gun dripping →